Our crews are certified, insured and equipped for attic water damage. They find the hidden moisture and dry it properly.
You get a straight answer on cost up front, with every line explained and nothing hidden.
Call now and a real person picks up. We ask a few questions and send a crew, so the water stops spreading sooner.
Most people who call us have never dealt with attic water damage before. We walk you through it on the phone, then send a local crew with the right equipment.
There are two ways an attic ends up wet. Rain gets in from above through worn shingles, failed flashing, or the seals around vents and chimneys. Moisture also rises from the house below and condenses on cold roof sheathing when the attic is not ventilated well. Either way, hardly anyone goes up there to look. In Bozeman, we inspect the attic, track down the source, and get it dry.
On the typical attic job, soaked insulation is the main issue. Heating and cooling bills go up because cellulose and fiberglass alike give up R-value when wet. Worse, soaked insulation holds water against the ceiling drywall and the framing for weeks. We remove what is saturated, dry the wood with air movers and dehumidifiers, and treat any mold on the rafters or sheathing.
We save what can be dried properly and remove only what cannot. Moisture readings make that call, not guesswork.
Ask a Tech: (586) 231-9894| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Cellulose insulation | Still loose, with dampness limited to the surface | Soaked through or packed down, which is most of the time |
| Roof sheathing | Solid despite staining, with moisture readings back to normal after drying | Layers coming apart, soft spots, or a sag between the rafters |
| Ceiling drywall | Flat and dry, with a stain that sealing and repainting will cover | Sagging, crumbling, or it sat under soaked insulation for weeks |
| Recessed lights and wiring | An electrician finds them dry, clean and free of corrosion | The housing took in water, or its connections have corroded |
| Insulated ductwork | Insulation under the jacket is dry and the jacket has no tears | Insulation wrap is soaked, sagging with water, or moldy |
Rain that makes it through the roof falls into the insulation and is absorbed. Because the rooms below show nothing, the leak is missed and no roof repair happens.
Damp wood and paper facing in a warm, still attic are ideal for mold. The sheathing, along with the top face of the drywall ceiling, is where growth can begin.
After repeated wetting, the insulation is saturated and water reaches the ceiling. Brown rings appear in the room below, and the drywall may start to sag.
Roofing nails loosen as the sheathing delaminates. Large areas of roof decking are covered in mold, while rafters that never dry begin to decay.
With poor ventilation, mold commonly grows on the bottom of the roof deck. It can cover a wide area before anyone goes up to look.
Insulation that is damp and compressed barely insulates, and drying may not bring it back. Energy bills climb, and the rooms below the wet area are hotter or colder than the rest.
Air handlers, with their drain pans and condensate lines, sit in many attics. For weeks an overflowing pan or blocked drain can drip into insulation, and there is no storm to tip you off.
An attic contains recessed light cans, junction boxes and runs of cable. Do not enter the attic before someone checks the power, because wet electrical parts can shock you or start a fire.
We check the roof deck, flashing points, vents and exhaust ducts to learn whether the water is a leak, condensation, or both. How far it spread is shown by moisture meters and thermal imaging.
We bag and remove insulation that is moldy or saturated, which lets the drywall and wood beneath it dry. The access path is kept contained and the living area underneath is protected.
With dehumidifiers and air movers, the sheathing, joists and rafters return to normal moisture levels. We clean visible mold off the wood, then apply an antimicrobial.
The roof or ventilation issue behind it is pointed out to you, and we are glad to pass what we found to your roofer. New insulation is installed to bring back the R-value after the attic is staying dry.
Not seeing your question? Call and ask. It costs nothing to talk it through.
Call (586) 231-9894Don't wait for small problems to become expensive emergencies. Call Bozeman Restoration for fast, reliable service.
Call (586) 231-9894 Now