Our crews are certified, insured and equipped for wall and drywall water damage. They find the hidden moisture and dry it properly.
Call now and a real person picks up. We ask a few questions and send a crew, so the water stops spreading sooner.
The quote is free and you see the price before work begins. No surprise charges at the end.
You do not have to work out how bad it is on your own. Call, tell us what you see, and a Bozeman technician will explain the next step and what it should cost.
A sheet of drywall behaves much as a wick does. Paper and gypsum pull water up from the floor line, so the wet zone frequently ends a foot or more past the highest point the water itself touched. Insulation and the rear of the panel can be wet through while the paint out front shows nothing unusual. That is why we check walls with a moisture meter instead of trusting how they look.
A wet wall does not automatically mean demolition. When the water was clean and the drywall remains firm, drying it where it stands is often possible, at times by pulling the baseboard and pushing air into the cavity through small holes. If the drywall has gone soft, crumbles, shows mold or took in dirty water, we do a flood cut, meaning a level cut over the damaged area with all material beneath it removed.
Sections of wall covered by cabinets, a vanity or shelving stay damp because air never reaches them. Meter readings at the toe kick and from the far side of the wall reveal it.
Outside walls have sheathing past the insulation that can also get soaked. It gets a moisture reading prior to closing, since it holds dampness a long time.
The back of the drywall is dark, still and lined with paper, which is ideal for mold. That side may be coated in growth even as the room side appears spotless.
Once wet, fiberglass insulation stays wet and keeps the studs damp. A wall with wet insulation will not dry from the room side alone.
Every wall is checked with a thermal camera and moisture meter, and we mark the height and reach of the water, covering the other face and the rooms next door.
Our call on each section, dry it or take it out, depends on water category, exposure time and the condition of the panel, and we explain it in plain terms.
Where the drywall stays, the trim is pulled and airflow is sent inside the wall. On sections coming out, a straight flood cut is made and soaked insulation is removed.
Drying typically takes 3 to 5 days of air movement and dehumidification before the framing and surviving drywall meter dry. After that comes insulation, new drywall hung and finished, trim put back and paint.
The bottom edge of the drywall takes in water from the floor and it begins moving up. The trim and the framing plate at floor level get wet too.
The wet line rises higher, baseboards swell and paint begins to blister. Inside the cavity, the paper face becomes a place mold can begin.
Paper peels from a core that is no longer firm. Within the wall the insulation sags, a smell develops and mold moves over the back of the panel.
By this point the studs and plates have been damp long enough for mold and early rot. A far larger section of wall needs tearing out and rebuilding.
It depends on the material, how long it stayed wet and how clean the water was. We test before we decide, and we tell you why.
Ask a Tech: (586) 231-9894| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Wall studs | Solid studs, as they dry readily with the wall opened | Rarely, and limited to wood with decay or deep mold |
| Drywall | Panels that stay hard and true after a short clean water event | Anything mushy, puffed up, moldy or touched by gray or black water |
| Plaster walls | Plaster that stays hard and bonded once dry | Plaster that crumbles to powder or has come loose from its backing |
| Paint and wallpaper | Painted surfaces with no blistering after the wall reads dry | Peeling paint and vinyl paper holding dampness against the wall |
| Outlets and switches | Receptacles the water never reached, confirmed by an electrical check | Any receptacle or switch that had water in the box |
Have a different question? Call us and we will answer it over the phone.
Call (586) 231-9894Take action now and prevent costly damage. Bozeman Restoration is ready to help.
Call (586) 231-9894 Now